Introductions: 1. The integrated machine can be packed separately to move into the lift with the width 2.2m and into the divided purifying workshop, it is easy to assemble the clamping screw. 2. Mould and guide rail should be designed separately, when changing mould, it only to change whole guide rail and mould pressing plate, it's easy to disassemble. 3. Photoelectric compensating mechanism is used to the diagrams and letters register on the printed Alu foil. 4. Main motor adopts frequency speed regulation: can setting punch frequency according to the different distances of stroke and different filling compound. 5. Manipulator grip feeding mechanism is drove by precision silk pole, controlled separately by servo motor with running smoothly and synchronous accuracy. The length of stroke can be designed according to the customer's requirement, also it can adjust through PLC control panel. 6. The forming heating plate can automatically open and close, the machine can start working with a time-delay to limit the plastic waste in one round of stroke after putting down the heat plate. Because it adopts contact type register heating, the heating power and temperature is reduced, power is saved and stability of blister sheet becomes stronger. 7.Air-cushion heat-sealing: when the machine stop, the net web plate lifts automatically by cylinder thus avoiding the blister deformation caused by heating radiation during staying of PVC, easy to clean net web plate and playing a role of slowing down super pressure for the benefit of extension of its service life. 8. Upper and lower couple contact heat-sealing: both the obverse and inverse plates are point-checkered shape (also can be line heat-sealing ), because they have equal stress, the plates are flat and improve the sealing performance. 9. Double-acting feeder: improve the feeding rate of ir-regular-shaped tablet and feeding rate is also raised by high speed operation (suitable for AL/PL packing). 10. At the end or cutting stop of PVC, the machine has functions of auto-alarm and auto-stop and is associated with emergency stop safety device. Therefore, it improves the safety of operation when adjusting and changing moulds. 12. All the parts including second feeding hopper which contact with medicine directly, are made of stainless steel and innocuous materials, conforms to GMP requirement.